Stainless Steel End Cap

PIC-(Stainless Steel End Cap)

　　Stainless Steel End Cap is also called the plug or head.Purpose: welding on the pipe end or installed outside the pipe thread to cover wall pipe fittings.Close to line, the same as the plug.

　　Pipe cap including convex cap, conical shell, variable diameter section, the design of the flat cover and tighten.

　　Convex tube caps include: hemispherical tube cap, oval tube caps, disc pipe cap and QiuGuanXing cap.From the standpoint of stress, convex cap in the gradually from hemispherical tube cap is not good, but look from the manufacturing difficulty, good manufacture gradually.

　　304 l stainless steel: 304 316 316 l, 321, 2520, 310, 316, such as material.

　　Size: DN15-48 ")

　　Wall thickness: SCH5 - SCH160

　　Standard: ASME DIN JIS BS GB/T, JB SH HG

　　USES: water, beverages, beer, food, petrochemical, nuclear power, chemical fertilizer, shipbuilding, machinery, medical equipment, waterproof processing, pipeline, etc

　　Packing: packed in wooden cases, cartons service: provide technical advice, installation guide, etc

　　Disc cap r, avoid joining together, will be thinned and high stress.

　　Splice weld direction when asked to only allow is radial and ring.After large cap may cancel this request.Stitching distance requirements, for more than 3 g, and not less than 100 mm (welding heat affected zone is high stress zone, and in the chemical composition of the area will be a loss. So to avoid the high stress area, the area and thickness. According to the practical experience, the stress attenuation length is greater than 3 g, and not less than 100 mm).But refrigeration equipment is difficult to meet the requirements, has its particularity.